The standard working force (1 million strokes) achieved 29.4 kN with the mounting width of 52mm. The allowable working force (300 k strokes) is 58.8 kN.
A spring force jut under 10% of the working force is attained, which is optimum for high tensile strength steel sheets and thick plate piercing.
Available angle is 0 to 60 degree at increment of 5 degree
SGP GUIDE POST
SLSD CAM UNIT
The travel is about 1.5 times as long as the same model (SUCD) travel
Compact design with the mount width of 52mm and shut height of 135mm
Automatic alignment mechanism of the V-shaped guide
Standard Working Force (1 million strokes) 14.7kN, Allowable Working Force 29.4kN(300k strokes)
Available angle is 0deg to 50deg at increments of 5
ISO springs are used
SRX RUBBER SPRING
SRX is the product with special blending method of various rubbers. It is resistant to large deflection (35%) and high load. Permanent set is limited. It is very cost effective compared to coil springs or urethane springs.
Durability: Durability for 100 strokes (35% deflection)
Maximum deflection: 35%
Permanent set: 2 % or less (at deflection of 35% and 300000 strokes)
High buckling resistance: Buckling does not occur in parallel load.
Compact size; Since the deflection is large, the free length is approximately half of coil spring.
Maximum load: The load is increased by approximate 10% more than the conventional parts